WTB Zillion J-Dream gear shaft

Is this so you can use a handle bolt instead of a nut? If so, I'd have to double-check length, but....Alphas CT or Steez may work. Alphas CT worked well in my Pink PO build...

@rise yes sir

@k3fishing edited my response above…

https://jdmfishing.com/into-the-pink/

Yes, it is looking to be different. 

Is it the alpha ct 70? That the shaft is from

Yes, looking to do the same thing as you did with the into the pink reel. Was it a direct fit or did you have to modify it?

Posted by: @k3fishing

↑

Yes, looking to do the same thing as you did with the into the pink reel. Was it a direct fit or did you have to modify it?

Swapped in. Are you going to carbontex drag? 

With the sv103 would that be a better option? Also if I have to do it then I definitely would. And if it’s better I would also do it. Are there any other parts/pieces that I will need to accomplish this? Or should I just try to follow what you did with the pink reel. Or are there some other things that should be added? Thanks 

Posted by: @k3fishing

↑

With the sv103 would that be a better option? Also if I have to do it then I definitely would. And if it’s better I would also do it. Are there any other parts/pieces that I will need to accomplish this? Or should I just try to follow what you did with the pink reel. Or are there some other things that should be added? Thanks 

carbontex is not needed, But I tune my reels based on applications. So if I’m using the SV 103 for frogging, flippin, etc… I’m upgrading the drag.

I asked because the Carbontex drag washers are a tad bit thicker and combining with the CT shaft will not allow for COMPLETE back-off of the drag. It will be very close, but that honestly doesn’t matter to me as the Carbon washers don’t compress like others/older stacks, and I never back my drag completely off. Adjustability is still 90+% there. 

thanks for the reply, I’m going to order a shaft or 4 , is there any other small parts that I would need when using the alpha CT shaft?